4-6. REMOVE AND REPLACE STAKES
Wrench, 7/16 inch
Step 1. Disconnect terminal lug from ground stud and remove jumper cables.
Step 2. Remove clamp.
Step 3. Pull cable out until damaged stake is free.
Step 4. Remove damaged stake from ground.
Step 1. Thread cable through new stake and through remaining stakes until all stakes are reattached.
Step 2. Replace clamp.
Step 3. Drive stakes in accordance with para 2-3.
Step 4 Reconnect terminal lug to ground stud and replace jumper cables.
REPAIR JUMPER CABLES
Wire, Ground, 10 feet
PC Clip, 75 Amp
Step 1. Disconnect terminal lug from ground stud and remove jumper cable(s).
Step 2. Using wire cutters, cut PC cllp(s) from cable.
Step 3. Using crimping tool, crimp PC clip(s) to cable.
Step 4. Reconnect terminal lug to ground stud and replace jumper cable(s).