TB 9-2300-295-15/11
DEPARTMENT OF THE ARMY TECHNICAL BULLETIN
TANK, COMBAT, FULL-TRACKED
105-MM GUN, M60A1, W/E (2350-756-8497);
TANK, COMBAT, FULL-TRACKED
152-MM GUN LAUNCHER, M60A2,W/E (2350-930-3590);
V E H I C L E , COMBAT ENGINEER, FULL-TRACKED:
M728,W/E (2350-795-1797);
LAUNCHER, M60A1 CHASSIS, TRANSPORTING:
F O R BRIDGE, ARMORED-VEHICLE-LAUNCHED,
SCISSORING TYPE, CLASS 60 (5420-889-2020); AND
TRAINER M37, TANK GUNNERY (6920-999-7792)
REPORTING OF VEHICLE DEFICIENCIES DURING
WARRANTY PERIOD CONTRACT DAAF03-72-C-0013
(CHRYSLER CORPORATION)
FOR
Headquarters, Department of the Army, Washington, D.C.
25 April 1973
complished in accordance with instructions contained
1. Purpose. This Technical Bulletin presents terms
in TM 38-750. Mail the completed forms to: Com-
of the contractor's warranty, identifies the category
mander, US Army Tank-Automotive Command,
of components, parts, and assemblies warranted;
ATTN: AMSTA-ME, Warren, MI 48090.
and prescribes the procedures to be followed for the
c. A comprehensive description of the failure
replacement of warranted components, parts, and
(photos, if possible), location, function, including
assemblies found to be defective during the period
nature and extent of defects, operating conditions
o f warranty.
at the time of failure, and man-hours expended
2. General. a. Exchange Tag, DA Form 2402, will
must be included on the DA Form 2407.
be used to identify items being held for warranty
d. When a warranted part fails, the replacement
claim exhibits. In each case, the tag will be marked
part should be obtained immediately. If the required
WARRANTY CLAIM EXHIBIT. Exhibits will be
part is not available from local supply sources, a
held pending disposition from the National Main-
supply requisition should be submitted to the pertin-
tenance Point (NMP).
ent supply distribution depot. Requisitions should
b. DA Form 2407 will be used to submit warranty
not be delayed pending inspection and acceptance
claim actions for all defective components, parts or
of the defective warranty part by the manufacturer
assemblies. DA Forms 2407 and 2402 will be ac-
1