L05-3825-222-12
FOLD
FOLD
-KEY-
LUBRICANTS
CAPACITY
EXPECTED TEMPERATURES
INTERVALS
Above +32F
+ 40F to -10 F
0F to -65F
OE-OIL, Engine, Heavy Duty
Crankcase
5 qts.
Intervals given are in
Air Cleaner
1/2 qt.
OE 30
OE 10
OES
hours of normal
Clutch and Reduction Gear Hous ing
1 1/2 qt.
operation
OES -OIL, Engine, Sub-zero
OHA-OIL, Hydraulic, Aircraft, Petroleum Base
Hydraulic Jack
3/8 qt.
ALL TEMPERATURES
GAA-GREASE, Automotive and Artillery
NOTES:
1. FOR OPERATION OF EQUIPMENT in PROTRACTED COLD
5. OIL CAN POINTS. Every 50 hours, clean and lightly coat governor and
TEMPERATURES BELOW 100F. Remove lubricants prescribed in the key-
throttle linkage, hinges and latches, and all exposed adjusting threads with
for temperatures above -10F. Relubricate with lubricants specified in the
OE.
key for temperatures below 10F.
Copy of this Lubrication Order will remain with the equipment at all times,
2. WHEEL BEARINGS. Every 1000 hours, remove wheels, inspect all
instructions contained herein are mandatory.
parts, replace damaged or worn parts, repack bearings, and reassemble.
BY ORDER OF THE SECRETARY OF THE ARMY:
3. OIL FILTERS. Every 100 hours, remove filter elements, clean housings;
install new element, fill crankcase, operate engine for 5 minutes, check for
leaks, check crankcase oil level, and bring to a full mark.
W. C. WESTMORELAND
General, United States Army,
4. LUBRICANTS. The following is a list of lubricants with the Military
Chief of Staff
Symbols and applicable Specification numbers
OFFICIAL:
OE MIL-L-2104
OES MIL-L-10295
OHA MIL-H-5606
GAA MIL-G-10924
KENNETH G. WICKHAM,
Major General, United States Army,
The Adjutant General
LO 5-3825-222-12 DISTRIBUTION : To be distributed in accordance with DA Form 12-25, Section II, (qty rqr block no. 442) Organizational Maintenance
requirements for Road Cleaning Equipment.
U. S. GOVERNMENT PRINTING OFFICE : 1993 - 342-022 (80312)
PIN: 030181-000