31 DEC 83
(Supersedes LO 5-3820-236-12, 7 JULY 1967)
AUGER, EARTH: SKID MTD, 9 FT BORING
DEPTH (TEXOMA ENTERPRISES MODEL 254-10)
Reference: TM 5-3820-236-15 and FEDERAL SUPPLY CATALOG C9100-1L.
Hard time intervals and the related manhour times are
Clean parts or fittings with dry cleaning solvent (SD),
based on normal operation.
The man-hour time
Type II or equivalent. Dry before lubricating. Dotted
specified is the time you need to do all the services
arrow shafts indicate lubrication on both sides of
prescribed for a particular interval. Change the hard
equipment. A dotted circle indicates a drain below.
time interval if your lubricants are contaminated or if you
Relubricate all items found contaminated after fording or
are operating the equipment under adverse operating
conditions, including longer than-usual operating hours.
The hard time interval may be extended during periods
of low activity.
If extended, adequate preservation
precautions must be taken.
The lowest level of maintenance authorized to lubricate
a point is indicated by one of the following symbols as
appropriate: Operator/Crew (C); and Organizational
improvements. You can help improve this manual. If
Dry cleaning fluid is flammable. Do
you find any mistakes, or if you know of a way to
not use near a flame or excessive
improve the procedures, please let us know. Mail your
Use only with adequate
letter or DA Form 2028 (Recommended Changes to
Publications and Blank Forms) direct to: Commander,
breathing of vapors and minimize
US Army Tank-Automotive Command, ATTN: DRSTA-
MB, Warren, MI 48090. A reply will be furnished to you.
*The time specified is the time required to perform all services at the particular interval.
CARD 1 OF 5